How to Realign the Motor in a Space Heater

Free shipping on orders over €65*

Introduction

The Comfort Zone CZ442 will produce a loud screeching noise if the motor is jolted out of alignment. Left in this state, the motor may eventually burn out completely. This guide covers the realignment of the motor.

What you need

Step 1 How to Realign the Motor in a Space Heater

How to Realign the Motor in a Space Heater, How to Realign the Motor in a Space Heater: step 1, image 1 of 1

Before you begin, unplug the heater from the outlet.
Remove the four rear Phillips screws. Apply firm pressure when removing all screws to prevent stripping.

Edit

Step 2

Carefully remove the front heater panel.

Edit

Step 3

How to Realign the Motor in a Space Heater: step 3, image 3 of 3

Remove the four Phillips mounting screws from the heater assembly.

Edit

Step 4

Slide the top control switch panel out. Be careful not to pull, or apply excess pressure to, any of the wires.

Edit

Step 5

Using pliers, remove the fan’s center mounting nut.

Edit

Step 6

Pull firmly to remove the fan from the motor.
Pull from the center of the fan. Do not pull on the fan blades.

Edit

Step 7

Slightly loosen both of the motor retainer screws about one full rotation.

Edit

Step 8

Push down on the motor bracket and adjust the motor by hand so it spins freely and does not scrape.

Edit

Step 9

Turn the thermostat selector fully clockwise, and the heater selector to “Fan.”
Make sure that the heater selector is clearly turned to the "Fan" setting. Any other setting could cause burns, fire, or electric shock.

Edit

Step 10

How to Realign the Motor in a Space Heater: step 10, image 3 of 3

Make sure the safety switch on the bottom of the heater is not being pressed. Wear the leather gloves, and plug in the heater.
The safety switch's normal function is to turn off the heater automatically if it tips over. Here, however, we can use it as a button to test the fan.

Edit

Step 11

Press the safety switch briefly to confirm that the motor can spin. Slightly tighten the screws and adjust the motor's alignment by hand until it can spin freely. A light rattling or noise is fine and will be fixed later.
Keep your fingers clear of the motor while it is spinning.

Edit

Step 12

Stand the heater case up, so the safety switch is pressed, and the motor is on.

Edit

Step 13

While the motor is running, slowly tighten the retainer screws until the motor runs smoothly and quietly.
If the screws are too loose, the motor will rattle or screech. If the screws are too tight, the motor cannot turn.

Edit

Step 14

Set the case back on its side, so the safety switch is no longer pressed, and the motor turns off.

Edit

Step 15

Align the fan to the motor axle, and press firmly to reattach it.
Press on the center of the fan only. Do not push on the fan blades.

Edit

Step 16

Briefly press the bottom safety switch to verify that the fan runs smoothly and quietly. If it does not, return to step 6.
Make sure your hands and other objects are clear of the fan

Edit