Rep: 33
2
Hi so I finally got the analog sticks on my controller these are the Gulikit TMR Joysticks and I dont know whats going out with the right analog stick it clicks, but doesn't register and it looks like it drifts even though they supposed to be new. I tried in BF6 and I don't notice it since I have my dead zone set to 0. Can too much or little solder cause that malfunction?
Is this a good question?
Rep: 45.5k
20
18
30
Hi!
Thanks for the pictures!
It does look like that the pads are damaged, causing this issue.
I’m afraid you need to repair the pads first.
Here is some explanation: https://youtu.be/dtZl7cLYc40?is=0ieMGMQp...
Please let me know how that goes!
Was this answer helpful?
Thank you I'll just a new MB and analog sticks it always something with this and its getting tiresome
I understand yes, I would swap it out for a new motherboard as well. Please let us know how that goes! Thanks!
Past 24 Hours: 3
Past 7 Days: 7
Past 30 Days: 63
All Time: 63
5 Comments
Hi!
Can you set us pictures regarding the solder work?
Adding images to an existing question
Thanks!
by koppie007
Hi, I uploaded the photos it starts from the top going clockwise
by Christopher D
Hi!
Thanks for the pictures! The pads do look damaged in the 2nd and 3rd photos. Can you remove the solder there and sent a photo again? Is that possible? Thanks!
by koppie007
I will do it as soon as I can
by Christopher D
Hi, I uploaded the removed solder from the 2nd photo I did noticed the exposed copper
by Christopher D